COUNTERFEIT COMPONENT DETECTION USING SOLDERABILITY TEST METHODS
The MUST is a highly accurate system that measures the forces imposed on a component or a circuit board sample at levels as low as 0.001mN otherwise referred to as “wetting force”.
The new MUST3 CVS Camera and Video System features a USB switchable camera with a special macro zoom lens and custom mounting assembly that retrofits to ALL MUST systems.
It is a visual aid used for correctly aligning and recording a component for a solderability test developed specifically to assist the operator in the testing of very small components (0402, 0201, etc.).
Comparing tests conducted on “good samples”, the MUST solderability results will vary according to differing wetting curves that are exhibited by differing surface finishes.
 |
 |
The MUST3 CVS complies with all current standards in the Electronics Industry –
IEC 60068-2-54 (Equates to BSI – JIS – DIN – AFNOR et al)
IEC 60068-2-69 (Equates to BSI – JIS – DIN – AFNOR et al)
IEC 60068-2-83 (Equates to BSI – JIS – DIN – AFNOR et al)
IPC J-STD002
IPC J-STD003
JEDEC
MIL STD 883
JEITA & JIS.
The MUST 3 CVS Solderability Tester - 5 tests in ONLY 1 machine –
1) Standard Wetting Balance testing using solder bath
2) Micro-Wetting Balance testing using Solder Globules
4 mm; 3.2 mm; 2 mm and 1 mm
Solder pellets: 200 mg; 100 mg; 25 mg; 10 mg, 5 mg
Accurately testing down to 0201
3) MUST Synchronous test using solder paste
4) NEW unique MUST Temperature Profile test
5) Reflow simulation
10th May 2012
We distribute equipment manufactured by some of the World's leading specialists, they are Marantz, ACE, Finetech, DIMA Technologies, Vacunest, Stoelting and MBTech.
